Bilby3D: TierTime / UP Spares

General Enquiries:

Phone: Freecall 1800-847-333
Fax: +61 2 8079 5971

Sydney - Alexandria, NSW
More

Unit 23, "The Bourke Centre"

Set Your Store

110 Bourke Road
Ph: 02 8197 3928

Brisbane - Spring Hill, QLD
More

Shop 2, 474 Upper Edward Street

Set Your Store

Ph: 07 3135 9810

Melbourne - Clayton, VIC

Factory A5, 2 Westall Rd, Clayton

Set Your Store

Ph: 03 8080 1200

Head Office - Bega NSW

452 Wyndham Lane, Kanoona. Ph: 02 8197 3930

Click above to set your Store

TierTime / UP Spares
Part for UP printers, made by TierTime, Distributed by 3D Printing Systems and Afinia

Related Sub-Categories: Build Platforms, Surfaces and Tapes | Desktop 3D Printers (All) | UP / TierTime Filament |

ptNozzleUPv3TC

UP Nozzle with Twin Clad Coating - 0.4mm - V3+ (8mm)

This Nozzle for UP Mini 2, UP Box and UP Box Plus 3D printers with internal M6 thread.

This aftermarket version by Micro-Swis has a hard-wearing non-stick TwinClad coating
More

ptNozzleUPTC

TwinClad Coated 0.4mm nozzle for Zortrax M200 + UP Plus 2 printers

This nozzle from US firm MicroSwiss fits Zortrax M22, Afinia and UP! style printers, it is made from a 360 brass base material and plated with TwinClad XT coating.

More

ptTapeBlShMiniPk50

50x Bulk Pack Blue Tape Precut Sheet (10x10cm) - Replicator 5th Gen Mini

This is a 50 sheet pack of our die cut self adhesive Blue tape is designed to fit the small printers of 10 x 10cm bed, but can also be used on other 3D printers, to help PLA, Wood or Brick filaments prints stick to the bed. It is 10 x 10cm. The backing peels off for easy adhesion.
More

ptHeatBlockUP

Heater Block for UP series printers - UNTIL SOLD OUT

This aftermarket heater block (also known as a thermal core) is a drop-in replacement for the UP! UP! Plus, Plus 2 and UP Mini printer. These printers are sold under the brands: Afinia, TierTime and 3D Printing Systems
Stripped the thread when changing nozzles? This is the part for you
More

ptFilterUPbox

HEPA filter for the UP Box (replace 3 mthly)

This HEPA filter enables the UP Box and UP Box PLUS to remove ABS fumes during printing and should be replaced every 3 months.
More

ptBarrelUP

Barrel for UP series printers

This is an aftermarket stainless steel heat break / thermal isolator / barrel for the UP! range of 3D Printers
More

ptUPboxBoardPerf

Perforated Build Plate for UP Box

Genuine Build Platform for the UP Box - Perforated version
More

ptCableUPext

UP Extruder Head - 14 pin ribbon Cable

This aftermarket ribbon cable runs from the motherboard to the extruder head
More

ptFanUPbox

Extruder Fan for UP Box

Genuine fan for UP Box and UP Box PLUS
More

ptUPboxLevelSens

UP Box Levelling Sensor (Square Plug)

The sensor which detects the level of your bed
More

Related Sub-Categories:

General Enquiries:

Sydney - Alexandria, NSW
More

Brisbane - Spring Hill, QLD
More