These small fans are often used to cool 3D Printer Hot Ends, especially on bowdon tube and rostock designs.
- 12V DC, 0.08A
- Connector PH2.0-2P (2mm pitch, 2 pin)
- 9 Blades
- Noise 26 dBa
- Sleeve Bearing
- 11,000 rpm
- 2.2 CFM Airflow
This turbine/turbo fan is often used to blow air onto the filament as it comes out of the nozzle, but it will work in any application where you need the air coming out of the fan circumferentially instead of axially
Black brushless fan, 32mm between holes. 10mm thick. Lead length is 220mm.
It has 7 blades. Draws 0.15 A
Compatibility: Be careful, your machine may only be designed to take a 0.1A Fan, available seperately
Genuine Makerbot brand fan for filament nozzle as used on the Replicator 2 (mounted left of the extruder) with 106cm long cables (red black), with an extrension join mid way, and white cable connector for motherboard. NOTE: this does not include the nozzle More
This little computer fan is great for keeping those components cool.
It has 7 blades and measures 50 x 50 x 10 mm
It is a bushed, brushless design, rated to 40,000 hours.
It claims to be low-speed and ultra quiet, but it is all relative. More
Filament Nozzle Turbo Fan as used in Replicator 2 - non genuine
This is a brushless fan, similar to that used in the Makerbot Replicator 2 with a nozzle attachement to blow cool air on the printout and rapidly set the plastic for better overhangs and thus higher resolution More
This mount screws down onto the extruder bar mount and secures the Active Cooling Fan (that blows onto your print our through the nozzle). When this part gets fractured or broken (which can happen from a serious print fail) the nozzle may droop and catch your print out. It is important to make sure you replace this part if you damage it. More
Fan, 80mm, 24V DC for Flashforge Dreamer
This fan is mounted on the rear wall of the FlashForge Dreamer
Genuine FlashForge part More
This Makerbot genuine brand fan is designed to fit on a Makerbot Replicator 2 or 2X (the cables are too short for the Ply Repliactors). It is 40 X 40mm. When fitting on a Makerbot Replicator the manufacturer label faces backwards not forward! More
Bilby 3D Pty. Ltd. Phone 1800-847-333 International +61 2 8197 3928
Australian Distributors of desktop sized 3D printers (FlashForge, Roland, Da Vinci, Repraps, Makerbot & UP printers), 3D Scanners, Tools & Parts
Sydney: 23/110 Bourke Rd, Alexandria, NSW 2015, Australia
Brisbane: 2/474 Upper Edward St, Spring Hill, QLD 4000
Melbourne: Coming to Victoria Feb/Mar 2017
Bega Head Office: 452 Wyndham Lane, Kanoona 2550