Bilby3D designed and 3D printed spool stand for 114mm wide spools.
Our 2020 design is bigger and stronger. It accomodates our 3kg spools, but will also carry our 1kg and 600g spools More
This stand holds spools up to 70mm wide (outside of flanges). The spool flanges sit on rollers and rotate as the printer pulls in the filament.
IMPORTANT: there is a wider model. This edition is thin enough to fit in the cavity of some printers, but is only just wide enough for most spools. (other mode)
FEEDER TUBE SOLD SEPERATELY order here for: 1.75mm, 3mm More
Chubbs the Purple Octopus is printed on a Makerbot Replicator 2 at 200 microns (each layer is only .2mm thick); using Bilby 3D brand PLA Purple. It takes 2 hours to print and has 3 Shells with 5% fill.
Size : 11cm tall. 10cm wide (at legs), 5cm at body.
Model designed by Andreas Boehler More
3D Printed Hilberts cube - Printed on FlashForge Dreamer
The 2 colour Hibert cube is printed on a Flashforge Dreamer at 200 microns (each layer is only .2mm thick); usingABS (usually Grey and Black, colours may vary). It takes 2 hours to print and has 5 Shells with 15% fill.
Size : 3cm square. 25g Model designed by TBuser More
The Geared Heart is printed on a Makerbot Replicator 2 at 200 microns (each layer is only .2mm thick); using PLA (colours may vary). It takes 20 hours to print and then assemble to geared heart. Once assembled you can spin the gears and keep spining until the heart re-appears.
It comes on its stand with an info card about the model, artist and 3D Printing
Size : 10 X 10cm, 5.5cm thick
Model designed by Emmetts More