This plastic scraper is ideal for smoothing tape onto your priter bed, and helping to remove prints and waste from your bed. One edge is sharp, the other has a soft fabric glued on (similar to loop velcro)
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
Related Products:
Buy Now
Polyimide (Kapton) Tape - 50mm wide - 33m long
This Polyimide (also known as Kapton) Tape is great for covering your build platform or providing electrical insultation. ABS stick to this when hot (with a heated bed), but releases easily when cold.
Buy Now
Polyimide (Kapton) Tape - 100mm wide - 30m long
This Polyimide (also known as Kapton) Tape is extra wide (100mm), great for covering your build platform when printing with ABS. The roll is approx 33m long and kapton is approx 0.02mm think
Buy Now
FlashForge Dreamer / Creator Pro Blue Print Bed Tape
This is a genuine FlashForge replacement sheet for the FlashForge Dreamer, Inventor1 and Creator Pro 2016 (v5) printing bed.
It is very similar to BuildTak but with more texture on the surface
Buy Now
Bed Tape for a Flashforge Guider 2 305 x 265mm
This is a genuine FlashForge replacement sheet for the FlashForge Guider2 printing bed.
It is similar to BuildTak, but with more surface texture, and can be cut down with scissors or a knife and used on other machines with a differently sized bed
Buy Now
FlashForge Inventor 2 / Finder2 Blue Print Bed Tape, 165x155mm
This is a genuine FlashForge replacement sheet for the Inventor 2 / 2S and 2SE printing bed.
Buy Now
Vinyl Bed Tape - Textured - For Makerbot Mini
This precut sheet of textured tape is ~ 110 x 110mm with cutouts for the metal sensing points (required for bed levelling). The texture means that your printout locks on to the bed much more strongly than using masking tape
Buy Now
Vinyl Bed Tape - Textured 285x165mm
This precut sheet of textured tape is 285x165mm to fit a Makerbot Replicator2 print bed. The texture means that your printout locks on to the bed much more strongly than using masking tape
Buy Now
Vinyl Bed Tape - Textured 250x250mm
This precut sheet of textured tape is 250x250mm to fit a Prusa up to a Printrbot PLUS v2.1 print bed. Slice 5cm of one edge for a Makerbot Replicator 5th Gen. If printing small items, you could cut into 4 pieces and just use it in the center of the bed. The texture means that your printout locks on to the bed much more strongly than using masking tape
Buy Now
Needle Nosed Pliers
130mm long needle nosed pliers.
Buy Now
Side Cutter - 110mm
Precision Sidecutters for cutting wire, leads etc.
Buy Now
Buildtak Spatula
With a right angled handle and a blade that is very thin at the front edge, this is a great tool for getting those really well stuck prints off the bed!
Sydney - Alexandria, NSW
Melbourne - Clayton, VIC
3D Printing
3D Printer Filament
Brisbane - Spring Hill, QLD
Bilby 3D Technical Support
3D Printer Service and Repair
Courses and Training
3D Scanners
Parts and Spares
Tools & Jigs