This nozzle has a Wear Resistant High Lubricity TwinClad XT Coating this makes it a excellent choice when printing with abrasive/wearing material such as Bronze, Copper, Alumininium or Carbon Fiber filament.

TwinClad XT is a nickel composite coating for very low frction. Over a 360 brass base, it gives a lower coefficient of friction than PTFE (Teflon) over nickel

This is dimensioned the same as our standard nozzle, as used on the Makerbot MK8 extruders.
ALWAYS run preheat before changing nozzles to avoid stripped threads.
Is is compatabnle with Makerbot:
- Replicator 1 (Single and Dual)
- Replicator 2
- Replicator 2x
- Craftbot 2
- CraftBot PLUS
- BQ Witbox
- BQ Prusa i3 Hephestos
- Creality CR-10
(Note Changing nozzle on a Smart Extruder is difficult and may void Smart Extruder warranty)
- Replicator 5th Gen
- Replicator Mini
- Replicator Z18


Next

Specifications:
Hole:0.6mm hole.
Thread: M6, 5mm long.
Total Length: 13mm.
Head width: 9mm (for better heat retention)
Base: Flat at screw/thread end (click photo under more info page for details).
Tip may have a slight flatened area.
Filament Size: suitable for 1.75mm filament.
CoatingTwinClad Coated


Dimensions: 13 x 7 x 7mm


Next

This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product