This item is no longer available. This information is for reference only
Heater Block Kit
This item is no longer available, you cannot order it
The Brass block holds everything together, there is a 3W Heat Resistor (6.9 Ohm) to provide the heat source, and a 100K Glass Thermistor for providing measurement to the controller. 2 x 0.5g satchets of Thermal Grease to help conduction with the heat resistor and thermistor.
Select a 3 or 1.75 mm Brass tube and Nozzle (not included) to complete your hot end.
Please Note: The Aluminium heater block has been updated so the small hole for the thermistor is now tapped to M3 so it can take a screw-type thermocoupler and the larger hole has a set screw for holding the heat resistor in place - could also hold a heater cartridge in place.
This 6.8 Ohm heat resistor provides a heat source for your hot end, or other application
Rating: 120V, 2.6W. 3W at 25 degC
Temp Coefficient: +-75ppm/degC
Operating Rage: -55 to 350 degC
Case Size: 5.5mm dia, 12mm long
M8 Hobbed Bolt - For Extruders
This bolt is used within some extruders to drive the filament. 50mm long.
Comes with 4 washers and an M8 Nylock nut.
All prices are in Australian Dollars and include GST. Standard Postage & Handling with Australia is $12 flat rate, free for orders over $350. Express Post starts at $14
Copyright 2016 Bilby3D. "Bilby3D" and the Bilby Logo are registered Trademarks of Bilby Publishing, used with Permission.
Bilby 3D Pty. Ltd. Phone 1800-847-333 International +61 2 8197 3928
Australian Distributors of desktop sized 3D printers (FlashForge, Roland, Da Vinci, Repraps, Makerbot & UP printers), 3D Scanners, Tools & Parts
Sydney: 23/110 Bourke Rd, Alexandria, NSW 2015, Australia
Brisbane: 2/474 Upper Edward St, Spring Hill, QLD 4000
Melbourne: A5/2 Westall Rd, Clayton, VIC 3168
Bega Head Office: 452 Wyndham Lane, Kanoona 2550