Our showrooms are open. Please follow local health advice
Hexagon Hot End Set for 1.75mm Filament
This complete hotend kit from RepRap discount includes; nozzle, heater block, barrel/heat barrier, fined heat sink, heater cartridge, thermistor, fan, mount and more in a plastic case
FeaturesSpecsSupport
This hotend kit from RepRap discount includes:
- The hotend (nozzle, heater block, barrel/heat barrier, fined heat sink.
- 0.4mm nozzle - Thread M6 and 6mm long
- Machined aluminium groove mount mounting plate
- 12v 30W Heater Cartridge
- EPCOS B57560G104F NTC Thermistor with lead and connector
- 12v Fan brushless fan with short lead
- Allen Key and set screws
- 4 + 4.5mm spanner (matches flat on barrel/heat carrier)
- In plastic case
Next >
Nozzle
0.4mm nozzle - Thread M6 and 6mm long
Metal / Abrasive Filaments
You should upgrade the supplied brass nozzle to a TC (tough coat) nozzle before printing abrasives, as they will wear out the hole to a larger size relatively quickly
0.3mm Nozzle - M6 Thread for Hexagon Hotend - Brass
This is a replacement nozzle for the Hexagon Hot-End
Buy Now
Push-In Hose Fitting - for 4mm tube, M6 Thread
These metal fittings are used for holding pneumatic (compressed air) tube. Designed for tube with a 4mm diameter made of Nylon or PU (PolyUrethane), they also work better than anything else we have found with PTFE tubing, which is very hard to hold due to its low friction. Has plastic collar - push down to release.
Buy Now
Bulldog Lite Extruder - 1.75mm - Until Sold Out
This tough little extruder includes everything you need to take filament from you spool through to pushing it into your hotend
Buy Now
0.4mm Nozzle - M6 Thread for Hexagon Hotend - Brass
This is a replacement nozzle for the Hexagon Hot-End
0.4mm Nozzle Hole, 1.75mm entry (0.5mm version shown)
M6 Thread, length 5mm
This is LulzBot / Hexagon hotend style nozzle. With M6 thread for 1.75mm Filament or PTFE Tube
Buy Now
Bills Extruder - v2 (Australian made)
This 3D Printer extruder is entirely Australian designed and made and designed to mount to most Nema 17 motors. Its simple and compact design provides reduce clogging through precision engineered Aluminium; and zero gap feeding (perfect for flexible filaments
This is a replacement nozzle for the Hexagon Hot-End
0.5mm Nozzle Hole, 1.75mm entry
M6 Thread, length 5mm
Buy Now
Standard Hot End Groove Mount
For Hexagon, JHead, UBis Hot Ends amoungst many others. This is an Aluminium Mounting Plate designed for use with many different hot-ends and extruders. It is used in RepRap Prusas, Huxleys and many others which is why it has become the standard.
Width: 30mm
Length: 70mm
Thickness: 4.5
All prices are in Australian Dollars and include GST. Standard Postage & Handling with Australia is $12 flat rate, free for orders over $350. Express Post starts at $14