Use this for sensing the temperature of your hot end, heated bed or whatever you can think of
Beta Value(K) 4036K
Operating Temperature: -60 to 300 degC
Bead Dia 2.13mm length 4.5mm
Lead Length 67mm
Cables - Two wire with connector - 70cm
These cables have two wires, red and black, and are terminated to the correct connectors to match the endstop pins on the RAMPS board.
Polyimide - 20mm wide - 30m long
Polyimide / Kapton Tape, 20mm wide.
The roll is approx 30m long and kapton is approx 0.02mm think
Heat Resistor 6.8 Ohm
This 6.8 Ohm heat resistor provides a heat source for your hot end, or other application
Rating: 120V, 2.6W. 3W at 25 degC
Temp Coefficient: +-75ppm/degC
Operating Rage: -55 to 350 degC
Case Size: 5.5mm dia, 12mm long
All prices are in Australian Dollars and include GST. Standard Postage & Handling with Australia is $12 flat rate, free for orders over $350. Express Post starts at $14
Copyright 2016 Bilby3D. "Bilby3D" and the Bilby Logo are registered Trademarks of Bilby Publishing, used with Permission.
Bilby 3D Pty. Ltd. Phone 1800-847-333 International +61 2 8197 3928
Australian Distributors of desktop sized 3D printers (FlashForge, Roland, Da Vinci, Repraps, Makerbot & UP printers), 3D Scanners, Tools & Parts
Sydney: 23/110 Bourke Rd, Alexandria, NSW 2015, Australia
Brisbane: 2/474 Upper Edward St, Spring Hill, QLD 4000
Melbourne: Coming to Victoria Feb/Mar 2017
Bega Head Office: 452 Wyndham Lane, Kanoona 2550