Prices + Stock updated 16 Jul @ 9:45
Thermistor - NTC 100K with 1m cable
Thermistor Cable for measuring the temperature of Hot ends and heated beds on Reprap, Prusa i3 and similar
Features
Specs
Support
1.3mm diameter glass thermistor on 1meter cable with bare ends
Next
1.3mm dia. Glass bead NTC 3950 thermistor
High Accuracy: 1%
Resistance value at 25°C: 100K
Thermistor value table already in Marlin firmware
Insulation: High Temp PTFE
Fits snugly in to thermistor hole of ptHeatBlock16 (16mm square heat block)
DOES NOT fit thermistor hole in ptHeatBlockM3D (20mm square heat block) - though the fixing screw will hold it against the heat block for measurement, or the hole could be enlarged. Just not as neat.
Apply Heat Grease to improve contact if required.
Dimensions: 1000mm x 1.3mm x 2.2mm
Next
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
This product is in the categories:
Related Products:
Buy Now
Heater Block - Aluminium Mini Size
This mini Heater block has a variety of pre-drilled and tapped holes for your layout. Anodised Aluminium with chamfered edges. Quality look!
All prices are in Australian Dollars and include GST. Standard Postage & Handling with Australia is $12 flat rate, free for orders over $350. Express Post starts at $14
Copyright 2019 Bilby3D Pty. Ltd.
Sydney - Alexandria, NSW
Melbourne - Clayton, VIC
3D Printing
3D Printer Filament
Brisbane - Spring Hill, QLD
Bilby 3D Technical Support
3D Printer Service and Repair
Courses and Training
3D Scanners
Parts and Spares
Tools & Jigs