Prices + Stock updated 26 Nov @ 8:16
Heater Block for the FlashForge Dreamer/Pro/Inv 1
Genuine heater block for the FlashForge Dreamer, Creator Pro and Inventor 1
Features
Specs
Support
Has a M7 tapped (threaded) and recessed hole for the barrel, and nozzle most other printers are M6!
Has an M4 drilled and tapped holes for the thermocoupler (temperature sensor)
Next
- Thermo connector thread M4
- Block dimensions: 19x19mm, 13mm tall
- Takes a MK10 nozzle and barrel (7mm)
Compatible with: The Flashforge Dreamer, Creator Pro, and Inventor 1.
NOT COMPATIBLE with other Flashforge Models
Note re Cocoon and Wanhao machines: They use an M7 threaded barrel and nozzle, so this is the best heater block to buy, but you will need 2 X m4 grub screws for the Heater block and thermo fitting (your current ones will be m3). ptHeatBlockFFF will work with no m4 screws but is smaller in size, your heater cartridge may extend too long.
Dimensions: 19x19x13
Next
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
This product is in the categories:
Related Products:
Buy Now
0.4mm Genuine FlashForge Nozzle - M7 Thread for MK10 Extruder
This is a genuine nozzle from FlashForge. M7 tread.
Buy Now
Flashforge Barrel for Dreamer / Creator Pro / Inventor 1
Genuine FlashForge barrel. It has a smooth outer tube with flats for holding with a spanner or pliers and a threaded end
Buy Now
Heater Cartridge for FlashForge 3D Printers Dreamer and Inventor 1 only
Genuine Spare part for FlashForge Dreamer and Inventor 1 only heater cartridge.
Note : Flashforge Creater Pro cable is different (see image 3, ptHeatCart4024)
Flashforge Finder, Guider (1 and 2) and Inventor2 also have a short heater. This is not compatible
Buy Now
Pre-Cut Ceramic tape with Kapton
Suits the Creator Pro, Dreamer and Inventor machines as well as a wealth of others. It is not self adhesive and you need Kapton tape to attach to your heat block.
Buy Now
FlashForge Thermocoupler - Short for Dreamer
Genuine FlashForge thermocoupler
M4 brass fitting at sensing end (Note: our other thermocouplers and heater blocks are all M3)
Crimped terminals at motherboard end
~11cm lead length - Suited to the FlashForge Dreamer which has a terminal board on the extruder carriage
Buy Now
Silicon Sock - Heater Block Cover for Dreamer / Inventor / Creator
This silicon rubber heaterblock cover suits the FlashForge Dreamer and Prusa i3
All prices are in Australian Dollars and include GST. Standard Postage & Handling with Australia is $12 flat rate, free for orders over $350. Express Post starts at $14
Copyright 2019 Bilby3D Pty. Ltd.