Switching power supply with temperature controlled fan and indicator LED
Widely used in Industrial automation, LED display, communications, etc.
- Input Voltage: 200V~240V/100V~120V ±20%
- Output Voltage: 24V DC
- Output Current: 0~15.0A
- 3 Pairs of output termials
Stepper Motor Driver Board - DM860A
The DM860A is a type of two-phase hybrid stepping motor driver for one motor. The drive voltage is from 24VDC to 80VDC. It is designed for use with 2-phase hybrid stepper motor of all kinds with 57mm to 110mm outside diameter and less than 8.0A phase current.
Inputs and Outputs are opto-isolated.
Overvoltage, under voltage, overcorrect, phase short circuit protection
14 channels subdivision and automatic idle-current reduction. 8 channels output phase current setting
Holding torque when the DM860A is run under high speed is also significantly higher than other two-phase drivers, what’s more, the positioning accuracy is also higher.
It is widely used in middle and big size numerical control devices such as curving machine, CNC machine, and computer embroider machine, packing machines and so on.
Replaces the older MD882 Driver
Stepper Motor - Nema 34
Nema 34 motor with 4 wires and a holding torque of 1150N.cm
Length 150mm, 86x86mm face, 69.6mm between the holes
Shaft Diameter is 14mm, 13mm across flats
Step angle is 1.8 degrees, rated current 3.5A per phase, phase resistance 1.8 Ohms and Inductance 21mH
Stepper Motor - Nema 23
Nema 23 motor. Step angle is 1.8 degrees, with 4 wires and a holding torque of 250N/cm.
Shaft diameter is 6.3mm
Stepper Motor - Nema 23 - 90
Nema 23 motor, step angle of 1.8 degrees, with 6 wires and a Uni-Polar holding torque of 90N.cm (127.5 oz-in or 9.18kgf-cm), Bipolar holding torque is 126N.cm
Length 54mm, 56x56mm face, 47x47mm between the holes
Shaft diameter is 6.35mm, length 21mm, no flat
Motor Phase Voltage: 3.6V
Insultaion Resistance 100M Ohm Min. 50V DC, Dielectric Strength 500V AC for 1 minute
Rated current 2A per phase, phase resistance 1.5 Ohms and inductance 2.5mH
FlashForge and Wanhao Power Supply - 24V, 350W
Power Supply for a range of FlashForge Printers, including the Dreamer and Creator Pro
Genuine part supplied by Flashforge
Also used in Wanhao machines such as the Duplicator 4
Stepper Motor Driver Board - TB6560 3A
This little stepper motor driver board is designed for a variety uses where you need to control one stepper motor. Link it up to your computer via one of our breakout boards