Prices + Stock updated 16 Feb @ 18:38
Stepper Motor - Nema 17 - 0.9 degree steps
This stepper motor is the standard for RepRaps and many of their derivatives.
Features
Specs
Support
It has a 0.9 degree step angle for applications where higher precision is required, and is 2 phase
Next
More Information
This stepper motor is the standard for RepRaps and many of their derivatives.
Specifications:
- 0.9 degree step angle, 2 phase
- 4 wire, 300mm, no connector
- Holding Torque of 4282 g-cm (42 N-cm, 59.5oz-in)
- 1.92V, 2.4A/phase
- Body 42.5 x 42.5 x 48mm long
- Mounting holes 31x31mm
- 5mm shaft diameter, 22mm long, no flat
- Equivalent to Wantai Motor 42BYGHM810
- Click more info for the datasheet
Dimensions: 42.5x42.5x72mm
Next
This product is in the categories:
Related Products:
Buy Now
Timing Pulley - T5 pitch, 10 teeth, Twin Flange
This Timing Pulley has 10 teeth. it is made of Aluminium with a set screw for attachment. Bore diameter is 5mm. It has 2 flanges (dia 20mm) suiting a belt width up to 6mm. Overall length is 17mm.
Buy Now
Stepper Motor Driver Board - DM542A
The DM542A is a type of two-phase hybrid stepping motor driver for one motor. It is designed for use with 2-phase hybrid stepper motor of all kinds with 42mm to 86mm outside diameter and less than 4.0A phase current.
Input Voltage: 18VDC to 50VDC.
Input Power: <4A up to 80W
Output Current: 1A - 4.2A(peak)
Inputs and Outputs are opto-isolated.
Overvoltage, under voltage, overcorrect, phase short circuit protection
Operating Temperature: -10 to 45 degreesC
15 channel subdivision and automatic idle-current reduction. 8 channels output phase current setting
Replaces the older MD542 Driver
Buy Now
Timing Pulley - XL pitch, 12 teeth
This pulley is made of fibergrass reinforced polycarbonate. It no longer has an Aluminium Hub with a set screw for attachment. It has a single flange and suits belts up to 9.5mm wide. Overall length is 20.64mm Flange Diameter is 25.1, hub diameter 12.7mm, with a 4.763mm bore to suit our Nema17 stepper motors.
T5 belt is not compatible with this pulley - see T5 pulleys
Buy Now
40 x 40mm Heat Sink, drilled for extruder cooling
This heatsink (40x 40 x 11mm high) is designed to fit on the back of a Nema 17 stepper motor, or the front of a Nema 17 based extruder as found on the Makerbot Replicator Series or MBot Cube.
Mounting Holes are 3.2mm diameter, 31mm apart. The center hole is aprox 12mm diameter
All prices are in Australian Dollars and include GST. Standard Postage & Handling with Australia is $12 flat rate, free for orders over $350. Express Post starts at $14