Prices + Stock updated 22 Jul @ 10:55
Thermistor, 100K NTC type, Radial Leads
Use this for sensing the temperature of your hot end, heated bed or whatever you can think of
Specs:
100kOhm
Tolerance +-10%
Beta Value(K) 4036K
Operating Temperature: -60 to 300 degC
Bead Dia 2.13mm length 4.5mm
Lead Length 67mm
Features
Specs
Support
Next
Dimensions: 71x2x2mm
Next
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
This product is in the categories:
Related Products:
Buy Now
Thermistor, 100K NTC, Axial Leads
Use this for sensing the temperature of your hot end, heated bed or whatever you can think of
Buy Now
Cables - Two wire with connector - 70cm
These cables have two wires, red and black, and are terminated to the correct connectors to match the endstop pins on the RAMPS board.
Buy Now
Polyimide - 20mm wide - 30m long
Polyimide / Kapton Tape, 20mm wide.
The roll is approx 30m long and kapton is approx 0.02mm think
Buy Now
Heat Resistor 6.8 Ohm
This 6.8 Ohm heat resistor provides a heat source for your hot end, or other application
Wirewound
Rating: 120V, 2.6W. 3W at 25 degC
Temp Coefficient: +-75ppm/degC
Operating Rage: -55 to 350 degC
Tolerance +-5%
Case Size: 5.5mm dia, 12mm long
Axial Leads
All prices are in Australian Dollars and include GST. Standard Postage & Handling with Australia is $12 flat rate, free for orders over $350. Express Post starts at $14
Sydney - Alexandria, NSW
Melbourne - Clayton, VIC
Bilby 3D Technical Support
3D Printer Service and Repair
3D Printing & Prototyping Service
Courses and Training
3D Printing
3D Printer Filament
Brisbane - Spring Hill, QLD
3D Scanners
3D Routers
Parts and Spares
Tools and Jigs
Gifts and Samples
Software
Books and Posters