This filament has been extensively tested and works well with standard ABS settings.
ABS (Acrylonitrile Butadiene Styrene) is a standard Engineering plastic such as used in car bumpers and helmets. It is known for not being as brittle as PLA, but not as flexiable than PET filament.
It has the drawbacks of a higher shrinkage rate than PLA (can lead to prints curling or splitting in extreme cases) and generally requiring a heated bed on your 3D printer.

We have tested this on over 10 different types of 1.75mm extruding machines with heated beds such as Makerbots, FlashForge, UPs, Printrbots and many more.

Next More Information

Diameter: 1.75mm (+/- 0.2mm)
Melting Point: 210 - 250 degC
Soften Point: TBA expected at 90 - 100 degrees
Abrasive: No
Build Surface: Hot bed (90-110°C;) on Kapton Tape or Buildtak. Glass with Gluestick

SPOOL SIZE
Type : Plastic
Inner hole: 5.2cm
Outer diameter: 20cm.
Width: 6.5cm

PACKAGING
Vacuumed in heavy weight clear plastic, then boxed.

Dimensions: 200x200x65mm


Next

This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product

10% Bulk Discount available; Order 10 or more filament at once, Prepay for your order, Phone 1800-847-333 to order. Conditions apply.

Product Material Safety Data Sheet