Genuine MakeX Resin Tank/Vat for the M-One, XGA and HD models.
This is the Flex Vat V2.
This breakthrough technology does away with the old silicon resin coated vats, which are easily damged and become cloudy after as few as 10 prints in the same spot.
Instead this tank had a flexible FET film, which lessens the load on the machine when peeling off the print after each layer, PLUS it is easily and (relatively) inexpensively replaced!
Each tank comes with 1 film pre-installed, and a spare for you to use later.
- Peel the protective paper of the perspex panel, this sits in the base piece with the perspex UP, so the lower piece is raised in the middle
- Place the tank itself on top, so the raised section pulls the film tight
- Add the fixing screw with spring - wound in about half way only
Dimensions: 230 x 145 x 43mm
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
Genuine MakeX Build Platform / Table for the M-One, XGA and HD models.
Has adjustment screws for levelling and a super thick aluminium platform
Resin Wash Kit
This kit includes the items most commonly needed when you are using resin printers:
250ml Squeeze Bottle - For Isopropyl Alcohol for washing excess resin from your prints
500ml Squeeze bottle - For water to rinse you prints after washing
2 x 3ml Squeeze droppers - For fine washing work or where rough measurement is required
Stainless Steel Funnel with grid and handle - Funnel for returning unused resin to the lightproof bottle. Has a grid for removing any cured resin floating in the vat which you do not want there! The grid easily clips out for washing
Just buy vinyl gloves and a pyrex dish of suitable size from your local supermarket, and you are all set to go!
All prices are in Australian Dollars and include GST. Standard Postage & Handling with Australia is $12 flat rate, free for orders over $350. Express Post starts at $14
Copyright 2016 Bilby3D. "Bilby3D" and the Bilby Logo are registered Trademarks of Bilby Publishing, used with Permission.
Bilby 3D Pty. Ltd. Phone 1800-847-333 International +61 2 8197 3928
Australian Distributors of desktop sized 3D printers (FlashForge, Roland, Da Vinci, Repraps, Makerbot & UP printers), 3D Scanners, Tools & Parts
Sydney: 23/110 Bourke Rd, Alexandria, NSW 2015, Australia
Brisbane: 2/474 Upper Edward St, Spring Hill, QLD 4000
Melbourne: Coming to Victoria Feb/Mar 2017
Bega Head Office: 452 Wyndham Lane, Kanoona 2550