Our showrooms are open. Please follow local health advice
Nobel 1.0 SLA Resin - Transparent - 2 x 500ml bottles
Resin specially designed for your Nobel 1.0 Printer from XYZ Printing
2 x 500ml Bottles of TRANSPARENT resin
FeaturesSpecsSupport
Install the resin in just three simple steps!: Replace the cap, insert the bottle, and connect the tube.
The printer will then detect the color, material, and remaining level of the resin, and automatically fill the tank and fine-tune the laser parameters to accurately print your design in all of its intricate detail.
Pack includes spare lids and tubes
Next >
Recommended Temperature for Storage: 15-27°C (59-80°F) - Avoid keeping the resin in environments exceeding 60°C (140°F)
Operating Temperature: 18-35°C (64.4-95°F)
Dimensions: 150 x 80 x 80mm
Next >
1 Year Warranty
Important Safety Notices
1. Heating of this product is strictly prohibited. Photopolymer resins may generate vapors that may cause discomfort when subject to high temperatures.
2. Please keep the product in a well-ventilated space out of childrens reach.
3. Avoid skin or eye contact with the uncured resin. If accidental contact occurs, please immediately rinse the affected area thoroughly using clean water.
4. Uncured resin in the tank may be solidify if exposed to sunlight before disposal. Therefore, be mindful when discarding uncured resin and do not pour material directly into the sink.
5. After printing, any uncured resin on the surface of the printed object must be cleaned away using alcohol.This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
Material Safety Data Sheet
All prices are in Australian Dollars and include GST. Standard Postage & Handling with Australia is $12 flat rate, free for orders over $350. Express Post starts at $14