Related Products:
Buy Now
Printer Setup Service - Sydney Metro (40km)
Delivery, unpacking and setup of a Bilby3D supplied desktop 3D printer within 40km of our Sydney base in Alexandria.
This does not include anything other than very basic training on the use of the machine. Additional training available separately.
Buy Now
0.6mm Nozzle - M7 Thread for MK10 Extruder - TwinClad Coating
This wear resistant nozzle by Micro Swiss suits a range of printers with an M7 thread and 0.6mm hole
Buy Now
0.2mm Nozzle - M7 Thread for MK10 Extruder - Twin Clad Coated
This This wear resistant nozzle by AVN/Micro Swiss suits a range of printers with 1.75mm filament. It has an M7 thread and 0.2mm hole.
Buy Now
Printer Setup Service - Brisbane Metro (40km)
Delivery, unpacking and setup of a Bilby3D supplied desktop 3D printer within 40km of our Brisbane base in Spring Hill.
This does not include anything other than basic training on the use of the machine. Additional Training available separately.
Buy Now
Printer Setup Service - Clayton Metro (40km)
Delivery, unpacking and setup of a Bilby3D supplied desktop 3D printer within 40km of our Melbourne base in Clayton.
This does not include anything more than very basic training on the use of the machine. Additional training available separately
Buy Now
Roadcase for the Inventor 2/SE or Finder
This flight ready, rugged road case is designed to neatly store your Flashforge Finder, Inventor 2 or Special Edition 3D Printer, with a rear storage section for Filament, spare parts and power supply. It is on lockable casters for easy moving.
Buy Now
Extruder Flat Cable for FlashForge Finder
This cable comes out of the body of the machine and runs to the extruder.
Buy Now
Power Supply for FlashForge Finder+, Inventor2+, Inventor2SE
Note: Does not include the power lead that goes from the wall to the power supply
Buy Now
Heater Cartridge for FlashForge 3D Printers Dreamer and Inventor 1 only
Genuine Spare part for FlashForge Dreamer and Inventor 1 only heater cartridge.
Note : Flashforge CreatorPro cable is different (see image 3, ptHeatCart4024)
Flashforge Finder, Guider (1 and 2) and Inventor2 also have a short heater. This is not compatible
Buy Now
0.4mm Nozzle - M7 Thread for MK10 Extruders - Wear Resistant Twin Clad Coating
This This wear resistant nozzle by Micro Swiss suits a range of printers has an M7 thread and 0.4mm hole.
Buy Now
FlashForge Thermocoupler - Short with Molex connector
Genuine FlashForge thermocoupler with 11cm lead length and Molex connector for the Finder, Inventor2 and Guider Series which have a terminal board on the extruder carriage.
Buy Now
0.4mm Genuine FlashForge Nozzle - M7 Thread for MK10 Extruder
This is a genuine nozzle from FlashForge. M7 tread.
Sydney - Alexandria, NSW
3D Printing
Brisbane - Spring Hill, QLD
Bilby 3D Technical Support
3D Printer Service and Repair
Courses and Training
3D Printer Filament
3D Scanners
Parts and Spares
Tools & Jigs