All stores are open, please observe local health regulations
Finder Blue Print Bed Tape, 15x15cm
This is a genuine FlashForge replacement sheet for the Finder printing bed.
FeaturesSpecsSupport
Very similar to BuildTak, it gives unrivalled performane for getting items to stick to the bed for less warping and less print failures.
At 150x150mm, this tape is also a great size for an Da Vinci Jnr, UP Plus 2 or UP Mini and is compatible with a heated bed.
We have tested this bed surface with PLA, ABS, Nylon and PETG.
Tip: When removing the old tape, the glue is very aggressive. We recommend pre-heating to 80-100°C Peel off the old tape and use it side down) to wipe off any remaining glue. Allow to cool before fitting new sheet
Next
158 x 158mm, 0.6mm thick with the self-adhesive backing paper still on
Dimensions: 158 x 158 x 1mm
Next
Please clean with a clean cloth, a damp cloth, or slightly soapy cloth (then make sure you get all the soap off!).
Acetone or IsoPropyl Alcohol will ruin this surface - DO NOT USE!This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
Dreamer / Inventor / CreatorPro Blue Print Bed Tape, 23x15cm
This is a genuine FlashForge replacement sheet for the FlashForge Dreamer, Inventor1, Creator Pro 2016 (v5) and Creator Pro2 (IDEX) printing bed.
It is very similar to BuildTak but with more texture on the surface
Buy Now
Buildtak Spatula
With a right angled handle and a blade that is very thin at the front edge, this is a great tool for getting those really well stuck prints off the bed!
Buy Now
BuildTak (Mini) 10x9.5 cm
This amazing build tape is a special plastic (self adhesive) surface that is stronger and better than older tapes (such as Kapton and Blue Tape), and holds objects on the bed so well. It also lasts significantly longer than the delicate old tapes.
Buy Now
50x Bulk Pack Blue Tape Precut Sheet (10x10cm) - Replicator 5th Gen Mini
This is a 50 sheet pack of our die cut self adhesive Blue tape is designed to fit the small printers of 10 x 10cm bed, but can also be used on other 3D printers, to help PLA, Wood or Brick filaments prints stick to the bed. It is 10 x 10cm. The backing peels off for easy adhesion.
Buy Now
Bulk Pack Blue Tape Precut Sheet - 15x15cm - Pack of 25 sheets
This is a 25 sheet pack of our die cut self adhesive Blue tape designed to fit a 15 X 15cm bed, like the XYZ Jnr, but can also be used on other 3D printers, to help PLA, Wood or Brick filaments prints stick to the bed. It is 15 X 15cm. The backing peels off for easy adhesion.
Buy Now
3D Lac PLUS Bed Spray - 100ml Spray Bottle - Box of 12
Bed Adhesion and Anti-Warping Spray - easily spray a fine mist on your bed to ensure the print stays where it should, but still removes without fuss.
Buy Now
3D Lac PLUS Bed Spray - 100ml Spray Bottle
Bed Adhesion and Anti-Warping Spray - easily spray a fine mist on your bed to ensure the print stays where it should, but still removes without fuss.
All prices are in Australian Dollars and include GST. Standard Postage & Handling with Australia is $12 flat rate, free for orders over $350. Express Post starts at $14