This Silver Smoke coloured filament from Proto-Pasta prints like normal PLA, but softens at a much higher temperature.
See ProtoPasta High Temp in action on Instagram
This new formulation is higher performing, more obviously heat treatable, and lower cost. This tough PLA prints with ease but has a potential Heat Deflection Temperature (HDT) of as much as 140C (285F) depending on post-processing. This means parts retain more stiffness and form at higher temperatures (no warping on your sunny car dashboard).
No abrasive fillers so expect normal wear with standard nozzles.
Use standard PLA parameters with standard build surface preparation (blue tape, glue stick, or BuildTak). No heated bed required. Some shrinkage may occur in the annealing process, so dimension critical parts may need to be scaled as much as 2.5% to compensate.
Prints with standard PLA settings, on a cold bed.
For maximum performance, your prints should be heat treated (i.e. crystallized) in an oven until you see a change from translucent to opaque. There is an obvious visual change indicating the improved performance! We had good luck in a lab oven at 110°C (230°F) for an hour or less. We recommend leaving the supports on your parts, placing them on a non-radiating surface (like glass, ceramic, or composite), and letting them cool in the oven to minimize distortion. Parts can be baked at a lower temperature (though must be above 60°C for any change to occur) for a longer time with less risk of unwanted deformation.
Also available in Iridescent Ice colour
This new 1.75mm filament from Proto-Pasta is seemingly odorless at room temperature, but gives off the delicous smell of coffee when heated! Beyond this novel feature, it is the most beautiful pearlescent, translucent bronze color when printed and becomes very wood-like when heat treated
This coffee is in a base of the new PLA2 which is heat-treatable to give a higher softening temperature
Bilby 3D Pty. Ltd. Phone 1800-847-333 International +61 2 8197 3928
Australian Distributors of desktop sized 3D printers (FlashForge, Roland, Da Vinci, Repraps, Makerbot & UP printers), 3D Scanners, Tools & Parts
Sydney: 23/110 Bourke Rd, Alexandria, NSW 2015, Australia
Brisbane: 2/474 Upper Edward St, Spring Hill, QLD 4000
Melbourne: Coming to Victoria Feb/Mar 2017
Bega Head Office: 452 Wyndham Lane, Kanoona 2550