Prices + Stock updated 16 Feb @ 18:38
Glass Bed Upgrade for Flashforge Dreamer, CreatorPro2016 (NOT Inventor 1)
This cool upgrade kit gives your Dreamer, Creator Pro 5 (2016 Model) a lift out Glass bed, which will be super flat, and also safer and easier to remove prints from. (there is a different kit for the inventor 1). NOTE new machines have 12mm screws in corners and need 4 X 20mm counter head M3 screws- ask for them on order if needed
Features
Specs
Support
Custom Corner Brackets
We made the corner brackets that are the heart on this product using Proto Pasta High temp PLA. Annealing it for 4 hours at 70 degrees to make the brackets resistent to the heated bed.
The brackets were designed by Chris Bilby to have a spring tension to hold bed firm, while also letting go to remove the bed.
Glass Bed
Our glass beds are made in Australia using tough heat resistent glass, with soft curved edges, so there is no sharp edges to handle
The Wing nuts supplied are vital for tight attachement
Next
Kit contains:
2 x Glass beds - so you can lift one out, and instantly print on the other. 5mm thick for strength and flatness
5 x Corner brackets (1 spare just in case)
5 x wing nuts
1 x Z offset spacer.
See support tab for fitting instructions
Dimensions: 232 x 154 x 5mm
Next
How to fit your kit.
1. Remove and tape you have on the bed
2. Remove the 4 nuts located in the 4 corners of the bed (from underneith)
3. Slide a corner bracket up the screw in each corner fastened with the wing nut. Push the corner bracket in on both sides tight up against the bed as you tighten nut.
4. Apply tape to your bed as desiered and pop in the Glass bed by putting in back corners and pushng back slightly to pop in the front.
5. Remove the LOGO plate behind bed and place the Z axis spacer in - to trigger the Z endstop the 5mm sooner required for the glass bed.(See image 2)
6. Check levels, which should be fine, and print.This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
This product is in the categories:
Related Products:
Buy Now
FlashForge Creator Pro 2016
New Creator Pro 2016 (also known as the Creator 5). It features a steel chassis with a hood, display and navigation buttons, much like the Makerbot Replicator 2x (at less than a third the price).
Buy Now
Flashforge Inventor 1
This 2017 upgrade to the trusty Dreamer adds an onboard camera and greater build height to the twin extruder, heated bed and fully enclosed features
Buy Now
Flexible Bed Kit for Dreamer, Inventor
2 Part flexible bed kit.
Kit includes 2 build sheets + 1 base sheet
All prices are in Australian Dollars and include GST. Standard Postage & Handling with Australia is $12 flat rate, free for orders over $350. Express Post starts at $14