Prices + Stock updated 19 Jan @ 8:00
This heated bed is needed to print ABS reliably. It works very well surfaced with Kapton (Polyamide) Tape, sticking when hot, but releasing your printed object once cooled. This is also needed for PLA when covering your bed with Kapton
This revision of the board has two different input terminals to choose from, one for 12V and one for 24V.
Etched from 35um Copper layers on Laminate FR4 1.6+-0.15mm, it has solder mask and printing on both sides.
This is the second version of the board with holes for soldering the optional 1K Ohm resistor and LEDs (included). It also has a central hole to help locate a Thermistor to sense the temperature of the board (not included).
Board measures 214 x 214 x 3 mm.
Next
This product has no specific warranty. Bilby 3D will honor obligations under Australia Consumer Guarantee regulations if and where they apply to this product
Related Products:
Buy Now
Polyimide (Kapton) Tape - 50mm wide - 33m long
This Polyimide (also known as Kapton) Tape is great for covering your build platform or providing electrical insultation. ABS stick to this when hot (with a heated bed), but releases easily when cold.
Buy Now
Ceramic Bed Insulation - 200 x 200mm
Ceramic Tape Cut to a square of 200x200mm, around 2mm thick
Buy Now
Borosilicate Glass Bed for RepRaps, 200x212 - UNTIL SOLD OUT
These glass beds make a rugged printing surface. Some people swear by printing directly on to glass with glue stick, but we prefer the results we get when used in conjuction with blue or Kapton (polyimide) tapes.
Now MADE IN SYDNEY
Copyright 2011-2021 Bilby3D Pty. Ltd.