Prices + Stock updated 12 May @ 19:45
Slot in replacement for FlashForge machines with a cylindrical heatsink and 24V heater cartridge
Includes:
- FlashForge Heater block
- MicroSwiss TwinClad Nozzle
- MicroSwiss HeatBreak / Barrel
- FlashForge cylindrical heatsink
- Silicon Cover
- FlashForge Thermocoupler with connector
- FlashForge Heater Cartridge (24V, 40W)
All assembled and measure to spec by our technicians
Note: This assembled Hot End length once the heatsink attached the overall length is around 57.9mm. It will be slightly longer than original but still fits. However you MUST run Extruder calibration and then Level Routine after fitting.
See this fact sheet
Dimensions: 100x40x40mm
Format: Assembly
Next >
Related Products:
Buy Now
MicroSwiss All Metal Hotend Kit for FlashForge Finder, Guider, Inventor 2/2S/2SE-FFtc
Genuine Micro-Swiss all metal hotend upgrade for the FlashForge Guider, Guider 2
Finder, FinderPlus and Inventor2 recomend - ptKitMK10TC3
Comes with 0.4mm nozzle, range of other sizes available
Buy Now
Heater Block for the FlashForge Finder, Guider, Inventor 2-FFptfe-FFtc
Genuine heater block for the FlashForge Finder series, Guider Series and Inventor 2
Buy Now
Extruder Heatsink for Guider 2 / 2S - FFptfe - FFtc
Genuine FlashForge replacement part
Buy Now
FlashForge Thermocoupler - Short with Molex connector
Genuine FlashForge thermocoupler with 11cm lead length and Molex connector for the Finder, Inventor2 and Guider Series which have a terminal board on the extruder carriage.
Buy Now
Heater Cartridge for the Guider 2, Inventor 2/2s/se (24V, 18.5 long)-FFptfe-FFtc
Genuine FlashForge replacement part for the Guider 2 (NOT THE GUIDER 1-see specs tab), Inventor 2/2S/2SE
Copyright 2011-2022 Bilby3D Pty. Ltd.