Prices + Stock updated 12 May @ 19:45
This stepper motor is the standard for RepRaps and many of their derivatives.
This stepper motor is the standard for RepRaps and many of their derivatives.
Specifications:
- 0.9 degree step angle, 2 phase
- 4 wire, 300mm, no connector
- Holding Torque of 4282 g-cm (42 N-cm, 59.5oz-in)
- 1.92V, 2.4A/phase
- Body 42.5 x 42.5 x 48mm long
- Mounting holes 31x31mm
- 5mm shaft diameter, 22mm long, no flat
- Equivalent to Wantai Motor 42BYGHM810
- Click more info for the datasheet
Dimensions: 42.5x42.5x72mm
Next >
Related Products:
Buy Now
Timing Pulley - T5 pitch, 10 teeth, Twin Flange - UNTIL SOLD OUT
This Timing Pulley has 10 teeth. it is made of Aluminium with a set screw for attachment. Bore diameter is 5mm. It has 2 flanges (dia 20mm) suiting a belt width up to 6mm. Overall length is 17mm.
Buy Now
Timing Pulley - XL pitch, 12 teeth - UNTIL SOLD OUT
This pulley is made of fibergrass reinforced polycarbonate. It no longer has an Aluminium Hub with a set screw for attachment. It has a single flange and suits belts up to 9.5mm wide. Overall length is 20.64mm Flange Diameter is 25.1, hub diameter 12.7mm, with a 4.763mm bore to suit our Nema17 stepper motors.
T5 belt is not compatible with this pulley - see T5 pulleys
Buy Now
40 x 40mm Heat Sink, drilled for extruder cooling
This heatsink (40x 40 x 11mm high) is designed to fit on the back of a Nema 17 stepper motor, or the front of a Nema 17 based extruder
Buy Now
Stepper Motor - Nema 17 - 1.8 degree 42BYGH26H-S-20Y
A high-torque standard Nema 17 stepper motor for many 3D printers
Copyright 2011-2022 Bilby3D Pty. Ltd.